标题: pamstamp 热冲问题 [打印本页] 作者: dadpopad 时间: 2009-11-10 16:29 标题: pamstamp 热冲问题 我在做pamstamp中遇到以下错误，求高手指点，小弟跪谢了！
Error : Cycle = -1 Progression = 0.000000 (Time = 0.000000)
in material type 117 definition
rupture number********* does not exist
--------------------------------------------------------------------------------
Error : Cycle = -1 Progression = 0.000000 (Time = 0.000000)
part id 23 curve corresponding temperature should be
defined increasing 0.112104e-43
--------------------------------------------------------------------------------
Error : Cycle = -1 Progression = 0.000000 (Time = 0.000000)
part id 23 curve corresponding temperature should be
defined increasing 0.980909e-44
--------------------------------------------------------------------------------
Error : Cycle = -1 Progression = 0.000000 (Time = 0.000000)
part id 23 curve corresponding temperature should be
defined increasing 0.224208e-43作者: kofkiller 时间: 2009-11-11 14:50
材料曲线有问题？？看看是不是你的热成型材料的HC曲线有问题作者: dadpopad 时间: 2009-11-12 14:23 2#kofkiller